Skip to main content

3. Transportation & Installation

3.1 Handling Procedures

image.png

 

3.1.1 Transport the control cabinet with a crane
Before transporting the control cabinet, perform the following checks:
1) Confirm the cabinet's weight and use a wire rope with a load capacity greater than the cabinet's weight for lifting.
2) Securely attach lifting eye bolts (M12 * 4) before lifting and ensure firm fixation.
3) The lifting eye bolts must not be disassembled

image.png

 

3.1.2 Transport the control cabinet with a forklift
When using a forklift to transport the control cabinet, adhere to the following precautions:
1) Ensure a safe working environment for moving the cabinet securely to the installation site.
2) Notify personnel working within the forklift's operating range to be mindful of the cabinet's movement.
3) Forklift operators should avoid shifting or tilting the cabinet during transport.
4) Keep the cabinet at the lowest possible height during transport.
5) Avoid vibration, dropping, or impacting the control cabinet throughout the handling process.

image.png

 

3.2 Installation
3.2.1 Installation guidelines
Environmental requirements:
 The operating environment temperature should be between 0°C and 45°C. During transportation and maintenance, the temperature range should be -20°C to 60°C.
 The relative humidity should not exceed 95%RH, and there should be no condensation.
 The installation site should have minimal dust, powder, oil fumes, and water.
 Flammable substances, corrosive liquids, and gases are not allowed in the operating area.
 The control cabinet should be installed in a low vibration or low impact energy environment (vibration below 0.5G).
 There should be no nearby electrical interference sources (e.g. gas shielded welding TIG equipment).
 There should be no potential hazards of collision with moving equipment (e.g. forklifts).
 There should be no ion or non-ion interference.
Instructions for Users: 

Please refer to the Instructions for Users and standardize your work.

3.2.2 Installation location
 The control cabinet should be installed outside the range of robot movement (within a safety fence)

image.png

 The control cabinet should be installed in a position where the robot's actions can be clearly observed.
 The control cabinet should be installed in a location that allows easy access for door inspection, with a minimum distance of 200 mm from front and rear walls to maintain clear maintenance pathways.
 There should be a distance of at least 200 mm on both sides of the control cabinet to ensure proper airflow.

image.png