1. TRANSPORTATION AND INSTALLATION
1.1. TRANSPORTATION
Turn each axis to transportation gesture before move the robot and be sure to keep the gesture during transportation until it be properly installed and mounted. Transportation gesture of each axis is shown below. Perform the transportation properly, or it may result in personnel injury or equipment damage.
Refer to theoretical weight of main parts shown below to install, disassemble and transport the robot.
When transporting the robot, a fixed bracket needs to be installed. The fixing bracket needs to be removed before installing the robot. The figure below lists the fixing bracket screw holes for easy user removal.
1.1.1.Transport by a forklift
The robot described in this manual can be transported by a forklift. Use eight M12X35 bolts to fix the 4 fixed plates on the forklift to the robot base, use a forklift to heave the robot. Make sure that the fixed bolts of the robot are removed before transportation.
1.1.2.Transport by a crane
The robot described in this manual can be transported by a crane. Fix the M12 rings on the robot rotation base, use a crane and strings to heave the robot. Make sure that the strings are fixed as shown in the figure below. Take necessary measures to avoid paint peeling due to collision between the strings and the robot.
1.2. INSTALLATION
The following precautions must be fully understood and observed before installing the robot.
Be sure to read and understand SAFETY chapter thoroughly.
ESTUN robots must be transported, mounted and operated by authorized person, and in accordance with the applicable national laws, regulations and standards.
Check the external damage of the robot package. Open the package and check the external damage of the robot.
Make sure the weight of the robot is within the forklift or crane load capacity. Details see Section 1.1 TRANSPORTATION.
Storage and mounting condition should be complied with Section 1.3 INSTALLATION CONDITION.
1.3. INSTALLATION CONDITIONS
See the table below about installation conditions. Robot storage conditions are also listed in case that the robot needs to be stored for a period of time.
Performance of resistant chemicals and resistant solvents.
(1) The robot cannot be used with the following liquids. Potentially these liquids will cause irreversible damage to the rubber parts (such as gaskets, oil seal, O-rings, etc.) (As exception to this only liquids approved by ESTUN can be used with the robot).
(a)organic solvents
(b)cutting oil including chlorine/gasoline
(c)amine type detergent
(d)acid, alkali and liquid causing rust
(e)other liquids or solutions that will harm NBR or CR rubber
(2) When the robot works in the environment using water or liquid, complete draining of J1 base must be done. Incomplete draining of J1 base will make the robot break down.
(3) Do not use unconfirmed liquid.
(4) Do not use the robot immersed in water, neither temporary nor permanent. Robot must not be wet permanently. Example, in case motor surface is exposed to water for a long time, liquid may invade inside the motor and cause failure.























No comments to display
No comments to display