Skip to main content

6. Device Connection

Device connection to the client software is required for device’s configuration and remote operations. This section introduces how to install the client software, set PC environment, connect the device to the client software, etc.

6.1 Install Client Software
IDMVS is a client software for device configuration and remote operations.

Steps 

image.png

1. Double click the installation package to start installing the client software.
2. Select the language.
3. Read and check Terms of the License Agreement.
4. Click Start Setup.
5. Select installation directory and click Next.

image.png

6. Finish the installation according to the interface prompts.

 

6.2 Set PC Network
To ensure stable client running and data transmission, you are recommended to set PC network.

Steps 

image.png

1. Go to PC network settings page: Start → Control Panel → Network and Internet → Network and Sharing Center → Change adapter settings.
2. Select NIC and set the IP obtainment mode.
● Select Obtain an IP address automatically to get an IP address of the PC automatically.
● Or select Use the following IP address to set an IP address for the PC manually.

image.png

3. Set NIC property.
1) Go to NIC settings page: Control Panel → Hardware and Sound → Device Manager → Network Adapter.
2) Select corresponding network interface card, and click Link Speed.
3) Set Speed and Duplex as Auto-Negotiation or 100 Mbps.

 

6.3 Set Device Network
You can set and operate the device in the client software only when the device is in the same network segment with the PC where the client software is installed.

Steps
1. Double click the client software to run it.
2. Click image.pngin device list to search the device.
3. Select a device to be connected.
4. Right click the device and click Modify IP.
5. Set the IP address of the device in the same network segment with the PC.
6. Click OK.

image.png

 

6.4 Connect Device to Client Software

image.png

Double click the device name in the device list, or click image.pngto connect the device to the client software.