Skip to main content

11. FAQ (Frequently Asked Question)

11.1 Why the image is very dark?
Problem
All black or too dark during preview.
Reason
● Insufficient brightness of supplement light.
● Too small adjustment value of exposure and gain.
● The polarization lens cap may be used. The brightness of polarization lens cap is low, and it is not recommended to use it in normal condition.
Solution
● Increase the brightness of supplement light appropriately, or change to a brighter one.
Increase exposure and gain appropriately.
● Increase exposure and gain appropriately.

11.2 Why the image's frame rate is very low in the live view?
Problem
Image incoherent/Low frame rate/Image tearing when adjusting the view preview.
Reason
Network circuitry speed is not 100 Mbps.
Solution
Check whether network transit speed is 100 Mbps or not.
Reason
● The device is powered off.
● Network exception.
Solution
● Check the device power connection (observe whether the top PWR light is solid green or not), to make sure the device is powered up normally.
● Check the network connection (observe whether the top LNK light is flashing green or not), to make sure the device can be connected to the network normally. PC port and the device are in the same network segment.

11.4 Why there is no image in the live view?
Problem
No image in the live view.
Reason
● Enabled trigger mode, but there is no trigger signal.
● Network circuitry speed is not 100 Mbps.
Solution
● Sent the trigger signal to the device/Disable the trigger mode.
● Check whether network circuitry speed is 100 Mbps or not.