Skip to main content

3.PRODUCT SPECIFICATIONS

3.1. ROBOT STRUCTURE

image.png

image.png

image.png

(Note 1) The maximum speed of each axis may not be reached during short-distance movement. The maximum motion range of each axis is measured when the robot is in the zero position, and the actual motion may be limited by the positions of other axes.
(Note 2) When the robot is used in a low temperature environment close to 0°C, or when the robot is stopped for a long time in an environment below 0°C on holidays or at night, immediately after the start of operation, the moving parts The resistance is great, and a collision detection alarm may occur. In this case, a few minutes of warm-up operation is recommended.
(Note 3) Please consult our company when using in environments with high temperature and low temperature, vibration, dust, cutting oil, etc. with high concentration.

image.png

Note: The moving trajectory space is 200×500×400mm, as shown in Figure 3.2:

image.png

 

3.2. DIMENSIONS AND MOTION RANGE
The following figure describes the motion range of the robot, which is used as a reference when selecting a robot and setting the installation position of the robot. When installing peripheral equipment, care should be taken to avoid interference with the main body and motion range of the robot.

image.png

image.png

3.3. ORIGIN POSITION AND MOVABLE RANGE
Zero point and motion range are provided for each controlled axis. Exceeding the software motion limit of a controlled axis is called overtravel (OT). Overtravel is detected at both ends of the motion limit for each axis. The robot cannot exceed the motion range unless there is a loss of zero point position due to abnormalities in servo system or system error.
In addition, the motion range limit by a fixed mechanical stopper or limit switch is also prepared to improve safety

image.png

image.png

image.png

Please refer to the operation manual for the setting operation of the movable range.

 

3.4. WRIST LOAD CONDITION
Robot load capacity (including weight of gripper or welding gun) coincides with robot model. Observe restrict of load torque and load inertia strictly. Refer to ESTUN robot bearing capacity calculation table when calculate load torque and load inertia. Contact ESTUN sales representatives for more detail.

image.png

image.png

image.png