3. Specification
3.1. Robot configuration
(Note 1) Short-distance movements may not reach the maximum speed of each axis. The maximum range of motion for each axis is measured when the robot is in the zero position, but the actual motion may be limited by the position of other axes.
(Note 2) When using the robot in low-temperature environment that is near 0°C, or when leaving the robot stopped in environments below 0°C during rest days or overnight, collision detection alarms may occur due to high resistance in the movable parts during the initial startup. In such cases, it is recommended to perform several minutes of warm-up operation.
(Note 3) For usage in high-temperature, low-temperature, vibrating, dusty, or environments with high concentrations of cutting oil, please consult ESTUN for guidance.
3.2. External dimensions and operating space
The following figures illustrate the range of motion of the robot and serves as a reference for selecting and setting up the robot's installation position. When installing peripheral devices, it is important to ensure they do not interfere with the main body of the robot and its range of motion.
3.3. Zero point position and motion limit
Zero point and motion range are provided for each controlled axis. Exceeding the software motion limit of a controlled axis is called overtravel (OT). Overtravel is detected at both ends of the motion limit for each axis. The robot cannot exceed the motion range unless there is a loss of zero point position due to abnormalities in servo system or system error.
In addition, the motion range limit by a fixed mechanical stopper is also prepared to improve safety.
Refer to system operation manual for more information about setting motion range.
3.4. Wrist load condition
Robot load capacity (including weight of gripper or welding gun) coincides with robot model.
Observe restrict of load torque and load inertia strictly. For the calculation of payload torque and payload inertia, please refer to the "ESTUN Robot Payload Capacity Calculation Table". For specific details, please consult our sales personnel.












No comments to display
No comments to display