Advanced Search
Search Results
904 total results found
ESTUN- General Small Payloads Series Robot Body Operation Instructions
Instructions for Safe Use
This Chapter describes the content to be observed for the safe use of the robot. Before using, be sure to read and understand the content in this Chapter.Companies and individuals using ESTUN Robotics should be familiar with the local and national standards an...
Preface
This manual is applicable to the following robot type. List of relevant instructions
1.Transportation & Installation
1.1. Transportation Before moving the robot, position each joint of the robot into the handling position to ensure that the robot remains in the handling position without any movement or displacement during transportation.The robot should maintain the handlin...
2. Connection with the Controller
The figure below shows the cables connect the robot with the controller. Connect these cables on the back of the base.
3. Specification
3.1. Robot configuration Figure 3.2 Robot configuration (ER12B-1510-LI, ER12B-1510) (Note 1) During short distance motions, the axis speed may not reach the maximum value stated.(Note 2) When the robot is used in low temperature environment that is near 0℃ ...
4. Equipment Installation
4.1. End flange mounting interfaceThis section describes the mounting face dimension of the end flange. Consider the depth of the screw holes and pin holes sufficiently before choose the length of the bolts and pins. Antirust measures of screws, grippers, etc....
5. Check and Maintenance
Before performing any maintenance, be sure to read SAFETY PRECAUTIONS in Chapter 1 and understand the content. 5.1. Daily checksCheck the items below before daily operation as occasion demands. 5.2. Periodic checks and maintenancePerform maintenance and ...
6. Zero Calibration
6.1. IntroductionZero Calibration associates the angle of each robot axis with the pulse count value supplied from the absolute Pulsecoder connected to the corresponding axis motor. To be specific, zero alibration is an operation for obtaining the pulse count ...
7. Troubleshooting
Be sure to read SAFETY PRECAUTIONS in Chapter 1 and understand its contents before any maintenance. 7.1. ToolsTroubleshooting tools includes travelling crane, forklift, internal hexagonal wrench, monkey wrench and special tools for removing the bearings. 7....
Appendix
Appendix A Screw tightening torque list Appendix B Specifications and technical parameters of chemical bolts Appendix C List of recommended spare parts for ER20B/10- 2010-HI (required for one unit/set) Appendix D List of recommended spare parts for ER...
Revision Record
ESTUN- General Medium Payloads Series Robot Body Operation Instructions
SAFETY
This chapter describes the precautions which must be followed to ensure the safe use of the robot.Before using the robot, be sure to read this chapter thoroughly. ESTUN robots must be transported, mounted and operated in accordance with national laws, regulati...
PREFACE
This manual describes the following manipulators. Related manuals
1. TRANSPORTATION AND INSTALLATION
1.1. TRANSPORTATION Turn each axis to transportation gesture before move the robot and be sure to keep the gesture during transportation until it be properly installed and mounted. Transportation gesture of each axis is shown below. Perform the transportation...
2. CONNECTION WITH THE CONTROLLER
The figure below shows the cables connect the robot with the controller. Connect these cables on the back of the base.
3. SPECIFICATIONS
3.1. ROBOT CONFIGURATION (Note 1) During short distance motions, the axis speed may not reach the maximum value stated. The maximum speed is measured at zero position of the robot, and will be limited by the position of other axes.(Note 2) When the robot ...