Advanced Search
Search Results
904 total results found
7. Client Operation Flow
7.1 Main Window IntroductionAfter logging into the client software, you can see the main window as shown below. 7.2 Operation Flow You can follow the overall operation flow below to create or edit projects via the client software.
8. FAQ (Frequently Asked Question)
8.1 Why the client software cannot list devices?ReasonDevice is not started up normally, or network connection exception occurs.Solution● Check device power wiring (observe PWR indicator).● Check network connection (observe LNK indicator). Ensure the device an...
ESTUN- ER8-MI series Robot Robot instruction manual
SAFETY
This chapter describes the precautions which must be followed to ensure the safe use of the robot. Before using the robot, be sure to read and understand this chapter thoroughly. ESTUN robots must be transported, mounted and operated in accordance with the app...
PREFACE
This manual describes the following manipulators Related manuals
1.TRANSPORTATION AND INSTALLATION
1.1. TRANSPORTATION Turn each axis to transportation gesture before move the robot and be sure to keep the gesture during transportation until it be properly installed and mounted. Transportation gesture of each axis is shown below. Refer below perform the tr...
2. CONNECTION WITH THE CONTROLLER
Connection cable between robot and control unit. Connect each cable to the connector on the back of the chassis.
3.PRODUCT SPECIFICATIONS
3.1. ROBOT STRUCTURE (Note 1) The maximum speed of each axis may not be reached during short-distance movement. The maximum motion range of each axis is measured when the robot is in the zero position, and the actual motion may be limited by the positions o...
4.INSTALL EQUIPMENT
4.1. END FLANGE MOUNTING INTERFACEThis section describes the mounting face dimension of the end effector. Consider the depth of the screw holes and pin holes sufficiently before choose the length of the bolts and pins. Antirust measures of screws, grippers, et...
5. CHECK AND MAINTENANCE
Before performing all maintenance activities, carefully read the first chapter on safety precautions. 5.1. DAILY MAINTENANCEWhen operating the system every day, the following items should be checked at any time 5.2.REGULAR INSPCTION AND MAINTENANCEInspec...
6. ZERO CALIBRATION
6.1.OVERVIEWZero calibration refers to the operation of correlating the angle of each robot joint with the pulse count value. The purpose of the calibration is to obtain the pulse count value corresponding to the zero position."Zero Calibration" is done before...
7. FAQ
Before performing all maintenance activities, read the safety precautions in Chapter 1 carefully 7.1.NECESSARY TOOLSCrane, forklift, Allen wrench, adjustable wrench and special tools for disassembling and assembling bearings, etc. 7.2.COMMON PROBLEMS AND SOLU...
APPENDIX
APPENDIX A SCREW TIGHTENING TORQUE TABLE APPENDIX B SPECIFICATION OF BELT APPENDIX C PARTS LIST OF ER8-720-MI (ONE SET REQUIRED) APPENDIX D PARTS LIST OF ER7-910-MI (ONE SET REQUIRED)
ESTUN- Extra Large Payloads Series Robot Body Operation Instructions
SAFETY
This chapter describes the precautions which must be followed to ensure the safe use of the robot. Before using the robot, be sure to read this chapter thoroughly.ESTUN robots must be transported, mounted and operated in accordance with national laws, regulati...
PREFACE
This manual describes the following manipulators. Related manuals
1. TRANSPORTATION AND INSTALLATION
1.1.TRANSPORTATION Turn each axis to transportation gesture before move the robot and be sure to keep the gesture during transportation until it be properly installed and mounted. Transportation gesture of each axis is shown below. Perform the transportation ...
2. CONNECTION WITH THE CONTROLLER
The figure below shows the cables connect the robot with the controller. Connect these cables on the back of the base.